Practice tool · free · uses your microphone
Online Drum Tuner
Tap the head near a lug and the tuner shows the pitch it heard in hertz and as a note name. Set one lug as the target, then bring the others to the same number for a clear, even tone.

The tuner needs JavaScript. The guide below still explains how to use one.
Waiting for a tap
- Target lug
- None yet
- Against target
- None yet
- Spread
- None yet
Recent readings: None yet
Press Start listening and allow the microphone when your browser asks.
How to tune a drum by lug pitch
- Seat the head. Finger tighten every tension rod, press the center of the head with your palm a few times, then give each rod a quarter turn in a star pattern, crossing the drum each time.
- Take a first reading. Rest one finger lightly in the center of the head. Tap about an inch in from one lug and let the tuner hear it.
- Set that lug as the target. Press the target button. Every later reading shows how far above or below it you are.
- Match the other lugs. Work around in the same star pattern. Tighten a lug that reads low and loosen one that reads high, in small turns of an eighth or less. Recheck the neighbors, since every change moves them a little.
- Move the whole head. Once the spread between lugs is within a few hertz, raise or lower every lug by the same small amount until the drum sounds right for the music.
What the tuner is measuring
A drumhead does not ring at one clean pitch like a guitar string. It produces a fundamental, which you hear best from the center, and a stack of overtones that are strongest near the edge. Tapping near a lug with a finger resting in the center brings out the edge overtone for that lug, and that is the number this tuner reads. It is the same idea a clip on drum tuner uses.
Because of that, compare readings with each other instead of chasing a number from a chart. Two drums of the same size with different heads will settle on different values. The useful facts are whether the lugs agree and what number gave you a sound you liked.
Top and bottom heads
The relationship between the two heads shapes the note. Both heads at the same pitch gives the longest sustain. A resonant head tuned higher than the batter shortens the note and adds attack, and a lower resonant head gives a deeper note with a falling pitch. Tune each head evenly first, then change the relationship one head at a time and listen.
Common questions
- Does the tuner record me?
- No. The sound from your microphone is measured in the page and thrown away. Nothing is recorded, saved or sent anywhere, and you can stop listening at any time.
- What pitch should my snare or toms be?
- There is no single correct pitch. It depends on the drum size, the heads and the music. Use the readings to make every lug on a head agree, then move the whole head up or down until you like the sound, and write the number down so you can find it again.
- Why do I get a different number each time?
- A drum produces several pitches at once and the loudest one changes with where and how hard you tap. Tap lightly with a stick or a finger, about an inch in from the lug, the same way every time, and rest a finger in the center of the head to quiet the low ring.
- Does it work on a phone?
- Yes, in current phone browsers that allow microphone access. Hold the phone a few inches above the drum and keep the room quiet.
- Can it replace a dedicated drum tuner?
- It does the same basic job of reading pitch at each lug. A dedicated tuner has a microphone and filters built for drums and clips to the hoop, so it is steadier in a noisy room.